Power Team Hydraulic Push Pullers

17½, 30-50 Ton

Previously difficult jobs made simple. Depending on how the puller is set up, a hydraulic pulling or pushing force can be applied. The stated tonnage capacity of each Push-Puller assumes use of the standard legs in tension. Capacity will be reduced if longer legs are used or the set-up sees the legs in compression. In every circumstance opt for the largest capacity puller/shortest legs suitable to do the job.

Features

Superb value for money. Push-Puller units have ideally matched hydraulic components that can be detached for other jobs providing optimum Power Team performance
Push-Puller with extra long or extra short reach enabled by optional leg kits
Power Team Push-Pullers can be used with an extensive array of bearing pulley attachments, internal pulling attachments and threaded adaptors
Power Twin® cylinder – Each Push-Puller is powered by a revolutionary centre-hole cylinder. The puller screw runs directly between the twin spring cylinder
Cylinder has a basic head design which enables you to change simply from a tapped hole to a plain hole

Specifications
Images
Applications
Setup
Warranty
PDF Datasheet
Help

	Capacity (Tons)	Order No	Description	Use With
Datasheet
	17½	PPH17	RT172 centre-hole Power Twin cylinder, cylinder half coupler, P55 pump, 9767 1,8 m. hose, 9798 hose half coupler, 419 mm legs, 24827 leg ends, 1"-8 x 508 mm lg. adjusting screw and adjusting crank.	Bearing pulling attachments: Nos. 1124 and 1130. Pulley pulling attachment: No. 679. Internal pulling attachment: No. 1154. Legs: Nos. 1104, 1105, 1106, 1107 and 1108 - Pair of legs for 171/2-ton “capacity” Push-Puller®.
		PPH17R	Same as PPH17, but without P55 pump, 9767 1.8m hose and 9798 hose half coupler.
		1062	Puller only. (Cylinder, pump, hose, coupler, screw and crank not included.)
	30	PPH30	RT302 centre-hole Power Twin cylinder, cylinder half coupler, P55 pump, 9767 1.8m hose, 9798 hose half coupler, 457 mm legs, 28390 leg ends, 11/4"-7 x 610 mm long adjusting screw and adjusting crank.	Bearing pulling attachments. No. 680 (Use two 8012 adapters to connect to puller.) Pulley pulling attachment: No. 679. Internal pulling attachment: No. 1166. Legs: Nos. 1109, 1110.
		PPH30R	Same PPH30, but without P55 pump, 9767 1,8 m hose and 9798 hose half coupler.
		1070	Puller only. (Cylinder, pump, hose, coupler, screw and crank not included.)
	50	PPH50	RT503 centre-hole Power Twin cylinder, cylinder half coupler, P55 pump, 9767 1.8 m hose, 9798 hose half coupler, 610 mm legs, 15/8"-5½ x 722 mm lg. adjusting screw and adjusting crank.	Bearing pulling attachments: Nos. 1128 and 1129. Legs: Nos. 1112 and 1113 - Pair of legs for 50 ton “capacity” Push-Puller®.
		PPH50R	Same as PPH50, but without P55 pump, 9767 1.8 m hose and 9798 hose half coupler.
		1076	Puller only. (Cylinder, pump, hose, coupler, screw and crank not included.)