Hydraulic Hoses

Polyurethane Rubber Non-Conductive

Place Enquiry

Catalogue PDF

All hoses have plastic hose guards except for the 1/4" I.D. polyurethane hoses which have spring guards. 3/8" NPTF fittings on both ends and a 10,000 psi operating pressure. All hoses comply with MHI standard IJ100.

• Non-conductive hose

  For applications requiring electrical isolation by the hose, non-conductive hose has a leakage factor of less than 50 microamperes, considered a safe level of conductivity by SAE standards. The covering is polyurethane and colored orange for easy identification as non-conductive hose. The covering is not perforated, preventing moisture from entering the hose and affecting its overall conductivity. All non- conductive hoses have a minimum burst pressure of 40,000 psi.

• Rubber hose

  2-ply rated hose reinforced with two braids of high tensile steel wire. The rubber covering is oil and weather resistant. These hoses are MSHA approved.

• Polyurethane hose

  Made up of nylon core tube with polyester fiber reinforcement which will withstand the minimum SAE bend radius without shortening service life. These hoses last up to seven times longer than rubber hose, and are suitable for continuous service at temperatures from -40^o to 150^o F.

• Hydraulic hose assembly

  No. 9764 - Hose assembly consisting of 9767 (6' hose), 1/4" I.D. polyurethane with 9798 hose half coupler and 9800 dust cap assembled.
  
  No. 9754 - Hose assembly consisting of 9756 (6' hose), 1/4" I.D. rubber with 9798 hose half coupler and 9800 dust cap assembled.