SPX -> Shop Maintenance -> H Frame 80-200T Press

Roll - Bed Press

80-200 Ton H Frame

The original, patented Roll-Bed design. Bed rolls out for easy loading and unloading with a crane or other lifting device.
Movable workhead glides easily side-to-side for full off-center load capacity across width of upper frame.
"Daylight" is 50 1/2" x 60" for 80- and 100-ton models; 51 1/4" x 64" on 150- and 200-ton presses.
Fast approach of double-acting, 13 1/8" stroke cylinder is provided by PQ1204S "Quiet" electric/hydraulic pump with remote control hand switch. Operator can view work from all sides with fingertip control of cylinder piston travel.

Roll-Bed design - Bed glides in or out on bearings to make loading and unloading fast and easy.
Adjustable lower bed width - For secure balancing and centering of heavy jobs. Loosen adjusting bolts to adjust bed from 4" to more than 27". See dimension "H."
Movable workhead - For off-center pressing jobs, workhead moves on bearings across upper bolster. Presses can be used at full capacity, regardless of where workhead is placed.
Lifting mechanism - Simply turn crank handle to raise or lower upper bolster. Screw mechanism raises or lowers both sides evenly (a heavy-duty 1/2" drill motor can replace handle for automatic adjustment). Four locking pins hold bolster in place for pressing.
Optional heavy-duty straightening fixtures - Make straightening jobs easy and accurate to within .004"! Rollers are ball bearing mounted and handle raises or lowers for easy turning of the work.

PQ120 Series - 3 hp, 460 volt, 60 cycle, three phase. Available in 220/380 volt, 50 cycle, add suffix "-380" to order no.

NOTE: To order press with a 230 volt, 60 cycle, single phase pump, order press less PQ1204S. Order pump No. PQ604S separately.

NOTE: Different voltage and valve options can be obtained by substituting certain PA, PE or PQ series pumps. Consult the factory.