Power Team 1070 30 Ton Hydraulic Push-Puller

The power to make impossible jobs become routine. Hydraulic 30 ton capacity push-puller only. (Cylinder, pump, hose, coupler, screw and crank not included.) A wide variety of optional legs, threaded adapters, bearing pulling attachments and internal pulling attachments can be used in combination with our Push-Pullers®.

Selection and Capacity Rating
Each Push-Puller’s specified tonnage “capacity” is determined using its standard legs in tension. Using longer legs, or a setup in which the legs are in compression, will reduce the “capacity”. Always select the largest “capacity” puller and the shortest legs that will fit the job.

Power Twin® Cylinder
This unique center-hole cylinder powers each Push-Puller®. Puller screw runs right between the twin spring cylinder. A basic head allows you to change from a tapped hole to a plain hole by merely changing the head insert.

Use With:
679 Pulley Pulling Attachment
680 Bearing Pulling Attachment (Use two 8012 adapters to connect to puller.)
1109 203mm Puller Legs
1110 457mm Puller Legs
1111 711mm Puller Legs
1166 Internal Pulling Attachment

NOTE: L = leg length: 4 1/2", 9 1/2", 16 1/2", 22 1/2", 30"; subtract 4 7/8" from leg length to determine reach when using leg end caps.

Leg Ends - Upper leg ends are threaded 3/4"-16" lg. Lower leg ends are threaded 5/8"-18" lg.