The SGS engineering 8L Air Compressor delivers excellent results through a wide range of applications such as spray-painting, inflating tyres or operating air tools. It has been hand-built out of aluminium and cast iron cylinder for efficiency and high quality so you can be sure you receive excellent results every time. This compressor displaces an impressive high flow of 5.5 CFM air displacement and 8 bar maximum working pressure. Featuring a large 8-litre receiver and single-stage, two-cylinder pump, this 1.1hp unit is the perfect compressor a wide range of applications, in any home garage.

	The powerful 1.1 HP motor is capable of delivering up to 5.5 CFM.
	The 8 litre tank is ideal for spraying, inflating, stapling, sanding, drilling and cutting.
	Boasting a quick-connect air outlet, pressure regulator and gauge.

Included:

8L air compressor
Combination 2 in 1 Air Nail & Staple Gun
10m long 8mm diameter Rubber Hose With Quick Couplers
Euro quick couplers
Air line oil

 

Compressor Specifications:

Engine Size: 1.1 HP
Power Consumption: 1kW
Voltage: 230 V @ 50 Hz
Rated Speed: 3450 rpm
Air Displacement: 5.5 CFM
Sound Level: 97 dB
Discharge Pressure: 115 PSI / 8 bar
Tank Capacity: 8 litres
Air Outlet: 1/4" BSP to Euro Coupler. The fitting can be swapped for PCL fittings, please check Fitting & Couplers section.

 

Nail Gun Kit Specifications:

Air Consumption: 1 SCFM
Magazine Capacity: 100 Nails / 80 Staples
Fastener Gauge 18 Gauge Brad Nails
18 Gauge Crown Staples 
Fastener Lengths Nails (mm): 15, 20, 25, 30, 35, 40, 45, 50
Fastener Lengths Nails (In.): 5/8, 3/4, 1, 1-1/4, 1-3/8, 1-1/2, 1-3/4, 2
Fastener Lengths Staples (Mm): 13, 16, 19, 25, 32, 38, 40
Fastener Lengths Staples (In.): 1/2, 5/8, 3/4, 1, 1-1/4, 1-1/2

Please note this compressor is for semi-pro and not commercial use

Does not include nails or staples.

Covered by a 2 year extended warranty.

Due to a change in EU legislation the safety valve rings have been removed by ALL manufacturers of air compressors. This is due to the ring being incorrectly used to vent the compressor, causing undue wear which should not be present on a safety device. The air should drained from the tank via the valve on the belly of the tank. This location is used so that the water is drained at the same time.